New Jersey residential appliance installer license prep class instal the last version for ipod

The auxiliary pan drain shall discharge to a conspicuous point of disposal to alert occupants in the event of a stoppage of the primary drain.

An auxiliary drain pan with a separate drain shall be installed under the coils on which condensation will occur.

One of the following methods shall be used: Drain piping shall be not less than 3/ 4-inch (19 mm) nominal pipe size. Such piping shall maintain a minimum horizontal slope in the direction of discharge of not less than 1/ 8 unit vertical in 12 units horizontal (1-percent slope). In addition to the requirements of Section M1411.3, a secondary drain or auxiliary drain pan shall be required for each cooling or evaporator coil where damage to any building components will occur as a result of overflow from the equipment drain pan or stoppage in the condensate drain piping.

The specified equipment or appliance manufacturer's published capacities cannot satisfy both the total and sensible heat gains calculated in accordance with the approved heating and cooling calculation methodology and the next larger standard size unit is specified.The specified equipment or appliance utilizes multistage technology or variable refrigerant flow technology and the loads calculated in accordance with the approved heating and cooling calculation methodology are within the range of the manufacturer's published capacities for that equipment or appliance.

Exception: Heating and cooling equipment and appliance sizing shall not be limited to the capacities determined in accordance with Manual S where either of the following conditions applies: And cooling equipment and appliances shall be sized in accordance with ACCA Manual S or other approved sizing methodologies based on building loads calculated in accordance with ACCA Manual J or other approved heating and cooling calculation methodologies.

New Jersey residential appliance installer license prep class instal the last version for ipod